4.7 Changing the position of the securing bar
Rail mounting position - wall mounting position
To change the securing bar from the rail mounting position to the wall mounting position follow
the steps below:
1. If necessary, loosen the knurled screw with your hand or a screwdriver.
2. Move the securing bar down as far as it will go.
– Use the levering aid and level the securing bar down using a screwdriver into this
position.
– Push the securing bar down using your hand.
3. Hold the securing bar in this position.
– Hold the securing bar with the screwdriver.
– Use the gap on the rear of the device and fix the securing bar briefly with a pin.
4. Tighten the knurled screw (torque 0.5 Nm).
The securing bar is fixed in the wall mounting position.
5. Remove the pin.
Wall mounting position - rail mounting position
To move the securing bar from the wall mounting position to the rail mounting position, loosen
the knurled screw.
Mounting
4.7 Changing the position of the securing bar
SCALANCE XC-200
46 Operating Instructions, 12/2017, C79000-G8976-C442-03
To Next Page
Loading...
Need help?
General