Siemens SIMATIC S7-300 CPU Data: CPU 315-T-2 DP User Manual

Memory concept
6.6 Memory of the integrated technology of the CPU
6.6 6.6 Memory of the integrated technology of the CPU
Memory utilization
The following table contains typical values for the memory utilization in the integrated
technology. The values refer to a CPU 315T-2 DP with firmware version V3.2 of the
integrated technology:
Technology CPU (6ES7 315-
6TG10-0AB0)
with hardware version 02
Base load of the integrated technology 25 %
Drive axis 1,25 %
Position axis 1,5 %
Following axis (with one following object) 2,5 %
Following axis (with two following objects) 3,5 %
External encoder 0,6 %
Cams 0,25 %
Measuring input 0,25 %
Cam (empty) 0,25 %
Cam interpolation points* 0,0046 %
Cam interpolation points to be interpolated* 0,0027 %
Maximum memory utilization
Recommended 80 %
* Further explanations can be found in the following calculation example.
Note
With insufficient memory, the Technology CPU goes into STOP mode. Note that these listed
values are only typical values and some commands may temporarily require more memory
during runtime.
If the memory utilization is excessive, online monitoring from S7T Config may no longer be
possible.
Therefore, the recommended calculated maximum memory utilization should not be
exceeded.
S7-300 CPU Data: CPU 315T-2 DP
6-18 Manual, 12/2005, A5E00427933-02

Siemens SIMATIC S7-300 CPU Data: CPU 315-T-2 DP Specifications

General

Brand	Siemens
Model	SIMATIC S7-300 CPU Data: CPU 315-T-2 DP
Category	Control Unit
Language	English