Siemens SIMODRIVE base line A User Manual

Installation
SIMODRIVE base line A Start-Up 2-17
2.6.2. Infeed module interface
General The pulse enable and drive enable interface is available in infeed module.
2.6.2.1. Grounding of electronics power supply - X131
General It is the reference potential terminal for electronics power supply. This
terminal (screw M4) should be connected with the protective conductor in
NC using a cable with cross-section 4mm
2
.
2.6.2.2. Enable interface terminals - X141A
General Terminal 63 is used for pulse enable input. Terminal 64 is for drive
enable input. They can be short-circuited with terminal 9, or controlled by
PLC.
Terminal 63 has the highest priority for enabling the pulses for all of the
modules and acts instantaneously.
Terminal 64 acts instantaneously on all modules. When the signal is
withdrawn, n
set
is set to 0 for all drives, and all of the controllers and
pulses are inhibited after a selected time has expired (setting when
supplied: 240 ms). The drive is braked along the current limit.
Terminal definition Table 2-7 Terminal definition
Term.
No.
Designa-
tion
Function Type
3)
Typ./limit
value(V)
Max.
Cross-
section
(mm
2
)
63 X141A Pulse enable I +13…30 1.5
9 X141A FR+
1)2)
O +24 1.5
9 X141A FR+
1)2)
O +24 1.5
64 X141A Drive enable
1)
I +13…30 1.5
R X141A RESET
1)
I 0/+24 1.5
19 X141A FR-, reference
ground, enable
signal voltage
O 0 1.5
1) Terminal 19 is the reference terminal (this is connected inside the
module to general reference ground X131 with 10 kΩ)
2) Max. current load, terminal 9 –terminal 19: 1A
3) I = Input, O = Output

Siemens SIMODRIVE base line A Specifications

General

Brand	Siemens
Model	SIMODRIVE base line A
Category	Controller
Language	English