10.7.4 Scaling
You can specify a scale factor for the active machining plane as well as for the tool axis. The
programmed coordinates are then multiplied by this factor.
New scaling Additive scaling
Parameter Description Unit
Scaling
● New
New scaling
● Additive
Additive scaling
XY Scale factor XY
Z Scale factor Z
10.7.5 Mirroring
Furthermore, you can mirror all axes. Enter the axis to be mirrored.
Note
Travel direction of the milling cutter
Note that with mirroring, the travel direction of the cutting tool (conventional/climb) is also
mirrored.
Programming technological functions (cycles)
10.7 Additional cycles and functions in ShopMill
Milling
656 Operating Manual, 08/2018, 6FC5398-7CP41-0BA0
To Next Page
Loading...
Need help?
General
