Approach and retraction
When machining the workpiece, you traverse from the current position to the machining start
point. After the machining process, the tool is returned along a direct path to the starting point.
16.7.1 Drilling with Manual Machine
Functions (cycles)
The same range of technological functions (cycles) is available as in automatic mode for drilling
on the face or peripheral surface of a workpiece:
⇒
⇒
⇒
⇒
⇒
Parameter
The parameters of the input screen forms correspond to the parameters under Automatic (see
Section "Drilling (Page 371)").
Working with Manual Machine
16.7 More complex machining
Milling
Operating Manual, 08/2018, 6FC5398-7CP41-0BA0 843
To Next Page
Loading...
Need help?
General
