You can unload tools from the magazine that you are not using at present. HMI then
automatically saves the tool data in the NC memory.
Should you want to use the tool again later, simply load the tool with the tool data into the
corresponding magazine location again. Then the same tool data does not have to be entered
more than once.
Procedure
1. The tool list is opened.
2. Place the cursor on the tool that you want to load into the magazine (if
the tools are sorted according to magazine location number you will find
it at the end of the tool list).
3. Press the "Load" softkey.
The "Load to… " window opens.
The "... location" field is initialized with the number of the first empty mag‐
azine location.
4. Press the "OK" softkey to load the tool into the suggested location.
- OR -
Enter the location number you require and press the "OK" softkey.
- OR -
Press the "Spindle" softkey.
The tool is loaded into the specified magazine location or spindle.
Loading empty magazine location directly with tool
1. Position the cursor at an empty magazine location where you want to
load a tool and press the "Load" softkey.
The "Load with ..." window opens.
Select the desired tool in the " ... Tool" field and press the "OK" softkey.
Several magazines
If you have configured several magazines, the "Load to ..." window appears after pressing the
"Load" softkey.
If you do not want to use the suggested empty location, then enter your desired magazine and
magazine location. Confirm your selection with "OK".
Multiple load points
If you have configured several loading points for a magazine, then the "Loading Point
Selection" window appears after pressing the "Load" softkey.
Select the required loading point and confirm with "OK".
Tool management
13.5 Tool list
Milling
706 Operating Manual, 08/2018, 6FC5398-7CP41-0BA0
To Next Page
Loading...
Need help?
General
