SNAW 1000 C1
■ 10
│
GB
2) If you wish to weigh without the bowl/container, lay the item to be weighed
on the weighing plate . The weight will be indicated.
If you wish to weigh the item in a bowl / in a container, first place the empty
bowl / the empty container onto the weighing plate . Press the button
ON/OFF/TARE . The display shows “0 g” and “T” appears on the
display . Place the items to be weighed in the bowl/container. The weight
of the items is shown.
Weighing additional items (tare)
To weigh in further amounts (e.g. flour and water for dough), you can set the
scales back at “0 g”.
■ If you wish to return the scales back to “0 g” after the first measurement so
as to measure the next ingredient, press the button ON/OFF/TARE
.
The display once again indicates “0 g” and “T” appears in the display .
Display nutrient and energy values
1) Place the items to be weighed on the scales.
2) Find the appropriate code for the food to be weighed from the food list.
3) Enter in the 3-figure code with the number buttons , e.g. 024. The display
then indicates the code and the weight.
NOTICE
► If you make an error when putting in the codes, briefly press the button
MC
C
.
The code will be deleted. Enter the code in once again.
4) To recall the nutritive and energy values, press the desired function button .
The required detail appears in the display .
If no further buttons are pressed, after approx. 8 seconds the display changes
back to the weighing mode and the weight is indicated. If you wish toswitch
straight into the weighing mode, press the button
de
The appliance indicates
the weight.
NOTICE
► Should you press a function button (except
,
de
), although a
code has not yet been entered, "Code" blinks in the display 3 times.
In this case, enter in the desired code.
NOTICE
► Due to natural fluctuations in the energy and nutritional values, only
approximate are possible.
To Next Page
Loading...
Need help?
General
