SNAW 1000 C1
GB
│
11 ■
Switching the scale off
To switch the scales off, press the button ON/OFF/TARE for about 3 sec-
onds. The scales switches itself off
or
wait for about 60 seconds after the last usage. The scales switches itself off
automatically
.
Saving a measurement
You can save all indicated values of a foodstuff. The scales automatically adds
together the values each saved measurement. Thus, for example, you can save
your entire food values eaten in one day and recall them at the end of the day.
The saved values are retained, even when you switch the scales off or change the
batteries.
You have previously made a measurement and entered the code.
1) Press the save button
M+
to save the measurement. In the display
appears “M”, the save location (e.g. 01) and the weight. M01 (or the last oc-
cupied space) is shown permanently on the display .
NOTICE
► If you press the save button
M+
without having previously entered in
a code, "Code" blinks 3 times in the display . Then enter in the required
code.
2) When you want to carry out and save the next measurement, press the save
button
M+
once again. In the display the next save position (e.g. M02)
appears.
3) To make further measurements, repeat the previously described steps.
NOTICE
► You can save up to 99 measurements (M99). When the memory is full,
it no longer permits measurements to be saved. In this case, delete the
saved data: press the button
MC
C
continuously until the indication
M99 (or the number of the last occupied memory space) extinguishes.
► If the nutritive value upper limit is reached with a memory input, "M" blinks
in the display and no further measurements can be added.
To Next Page
Loading...
Need help?
General
