Silvercrest SBDB 5 A1 User Manual

GB
│
IE
│
NI
│
15 ■
SBDB 5 A1
FM radio operation (FM)
Automatic station scan (AMS)
♦ This device must be switched on. If necessary, briefly press the button2
to switch on the device.
♦ If necessary, briefly press the SOURCE/ button 4 several times
until FM radio mode and the frequency display in Mhz is shown on the
display1.
♦ Briefly press the ENTER/SCAN button3 to start the automatic
station scan. The display 1 now shows the message Scanning....
The station scan stops at the next station with a sufficiently strong signal.
Storing stations automatically
The automatic station scan with station saving scans the entire frequency band
once and automatically saves the FM radio stations found as an FM station list.
♦ Press the
ENTER/SCAN button 3 for approx. 2 seconds to start
the automatic station scan with station saving. The display 1 now shows
the message Scanning... FM and the number of found stations. The scan
progress is displayed as a progress bar. The FM radio stations found are
automatically stored in the station list on order of increasing frequency.
When the scan is finished, the first station in the station list is automatically
played back.
NOTE
► An automatic station scan with station saving may overwrite an existing
station list.
Selecting stations
♦ Press PRESET 7 for about 2 seconds to call up the FM station list.
♦ Press TUNE+
9 or TUNE− 8 to select an FM radio station from the
station list.

Silvercrest SBDB 5 A1 Specifications

General

Brand	Silvercrest
Model	SBDB 5 A1
Category	Radio
Language	English