18 US-EN
TWS pairing
NOTE: This function is available two speaker link up with TWS (True
Wireless Stereo) playback.
Turn on both products and make sure they are both not connected to
another device via Bluetooth
®
to pair the TWS function.
Press the
button
10
on one of the products which will then by default
set it as the “master“ unit. A beep will sound. When pairing between both
products has been carried out successfully, the LED
5
of the connected
“slave“ unit stops flashing and a sequence of beeps will sound.
The “master“ unit LED
5
will still be flashing waiting to pair with the
playback device. Once the “master unit“ has successfully paired with the
playback device both the “master“ and “slave“ units can be played and
controlled synchronously during Bluetooth
®
playback mode.
Press the
button
10
again to break the TWS pairing connection, the
LED
5
on the connected “slave“ unit flashes and a signal tone sequence
sounds.
NOTE: The product which had its button
10
pressed first will become
the “master“ unit (in the left audio channel), and the other unit will then by
default becone the “slave“ unit (in the right audio channnel).
Handle band connection
You can attach the Handle band to carry the product for outdoor use.
Reference below diagram for the installation position.
To Next Page
Loading...
Need help?
General
