15 US-EN
Using the product
Press and hold the button
8
until the LED
5
flashes white slowly
and a signal tone sequence sounds. The product will now attempt to
connect to the playback device (e.g. smartphone or computer).
Establishing a Bluetooth
®
connection:
Remove all plugs from the AUX-in jack
1
before you attempt to establish
a Bluetooth
®
connection.
Switch on the playback device and make sures its Bluetooth
®
mode is on.
On the product press and hold the
button
6
for 2 seconds until
the LED
5
flashes white slowly and a signal tone sequence sounds.
The product will now attempt to connect to the playback device (e.g.
smartphone or computer).
The product identification on the playback device will be “SBL TW10
A1“. On the playback device “ACCEPT“ the connection. Please note the
requirements of the software on the playback device.
Once the connection is made the LED
5
flashes white briefly once every
five seconds and a signal tone sequence sounds.
The maximum range of the connection is 32.8 ft/10 m, but this may be
reduced due to the geometry of the space (obstructing furniture, walls,
etc.).
The playback device must support Bluetooth
®
standard 5.0 otherwise you
may not be able to use all the functions.
Functions of the buttons
Start a playlist on your playback device.
The product has 5 buttons and these control the following functions:
Button Function
‒ Press and hold for 2 seconds to switch the product on or off.
‒ Press briefly during playback to pause or continue
playback.
To Next Page
Loading...
Need help?
General
