Silvercrest SDB 2400 B3 User Manual

SDB 2400 B3
■ 20 │ GB
│
IE
Before first use
1) Remove the steam iron from the packaging.
2) Remove all stickers and protective films from
the steam iron.
WARNING – RISK OF
SUFFOCATION!
Plastic bags can be dangerous. To avoid the
risks of asphyxiation, keep plastic bags out of
the reach of babies and toddlers.
3) Fill the water tank with water (See the chapter
“Filling the water tank”).
4) Insert the plug into a mains power socket sup-
plying an electrical current as detailed on the
rating plate.
You will hear a beep, the display 1 switches
on and shows the word “STdby“ (Standby) in
red letters. The appliance is now in standby
mode.
5) To switch on the iron and set the temperature,
press the TEMP
3 button repeatedly until
11/MAX appears on the display 1.
6) Heat the steam iron up for several minutes at
the highest setting.
7) Activate the steam blast button 5 several times
so that steam comes out of the sole of the iron 0.
8) Then iron over a piece of scrap fabric to re-
move any production residues that may remain
on the sole of the iron 0.
9) Press the
TEMP 2 button repeatedly until
the display 1 reads “STdby“ (Standby) in red
letters.
10) Remove the power plug from the mains power
socket.
Automatic switch-off
This steam iron is fitted with an automatic switch-off
system. This stops the steam iron from heating up.
When the steam iron is resting on its sole 0 and
is not moved for approx. 30 seconds, 6 warning
beeps will sound while “PAUSE” appears in red in
the display 1. The steam iron will stop heating up.
To deactivate the automatic switch-off, lift up the
steam iron and move it gently from side to side.
The previously set temperature level is shown again
in white and the steam iron heats up again.
When the steam iron is resting on its base 7and
is not moved for approx. 8 minutes, 6 warning
beeps will sound while “PAUSE” appears in red in
the display 1. The steam iron will stop heating up.
To deactivate the automatic switch-off, lift up the
steam iron and move it gently from side to side.
The previously set temperature level is shown again
in white and the steam iron heats up again.
NOTE
The automatic switch-off is not intended as a
substitute for removing the plug from the mains
power!
It is merely designed to prevent the appliance
from overheating and helps to avoid unneces-
sary power consumption.
It does not provide fire protection, however, e.g.
if you place and leave the hot steam iron on
flammable material.

Silvercrest SDB 2400 B3 Specifications

General

Brand	Silvercrest
Model	SDB 2400 B3
Category	Iron
Language	English