Silvercrest SDBS 2800 A1 User Manual

SDBS 2800 A1■ 6
│
GB
│
IE
│
NI
│
CY
Before first use
■ Remove the steam iron from the packaging.
■ Remove all packaging materials from the
appliance.
RISK OF SUFFOCATION!
► Plastic bags can be dangerous. To avoid fa-
talities through suffocation, keep plastic bags
out of the reach of children.
■ Fill the water tank with water (See the chapter
"Filling the water tank").
■ Insert the plug into a mains power socket
supplying an electrical current as detailed on
the rating plate.
■ Move the temperature control 6 to the "MAX"
position.
■ Wait for the iron to heat up until you hear a
beep.
■ Pick up the iron and press the steam blast button
4 a few times so that steam comes out of
the sole of the iron q.
■ Then iron over a piece of old piece of material
to remove any residues that may remain on the
sole of the iron q.
Filling the water tank
■ Hold the iron in your hand at an angle.
■ Open the cover of the filler opening for the
water tank 2. This is marked with
.
■ Use the measuring beaker e to add tap water/
distilled water to the water tank up to no more
than the "MAX" marking that you can see
through the filler opening to the water tank 2.
■ Close the cover of the filler opening for the
water tank 2.
NOTE
If the mains water in your location is rated as
hard, it is recommended that you mix the mains
water with some distilled water. Otherwise, the
jets for the steam blast function could become
blocked with limescale prematurely.
To extend the optimal steam blast function, mix
mains water with distilled water according to the
table:
Water hardness Ratio of distilled
water to
tap water
very soft/soft 0
medium 1:1
hard 2:1
very hard 3:1
Ask your local water utility about the water
hardness in your area.

Silvercrest SDBS 2800 A1 Specifications

General

Brand	Silvercrest
Model	SDBS 2800 A1
Category	Iron
Language	English