Silvercrest SIKP 2000 D1 User Manual

SilverCrest SIKP 2000 D1
English - 19
7.2 Use

If you switch the induction hotplate off and the surface temperature of the heating zone
(2) is higher than 60 °C, "H" is shown on the display (7). If the temperature drops below
60 °C, the display (7) shows "L".
 If you remove the pan from the induction hotplate when in use and the surface
temperature of the heating zone (2) is greater than 60 °C, the display shows "H-E0" and
a beeper sounds every 4 seconds. After around 45 seconds, the beeper stops and only
"H" is displayed. About a minute later, the fan switches off. The display (7) continues to
show "H" as long as the surface temperature of the heating zone (2) is greater than
60 °C. If the temperature drops below 60 °C, the display (7) shows "L".

The only way to hide the “H” and “L” symbols from the display (7) is by disconnecting
the product from the mains.
 When the hotplate is switched on, the preset power level is 1000 W.
1. Connect the hotplate to a live wall socket using the power cord (1). A beeper then sounds and the
display (7) shows "L" or "H" depending on the temp
erature.
2. Place a pan on the hotplate (2).
Warning about property damage

The pan must be explicitly suitable for induction hotplates. Do not use any other pans
(e.g. ceramic ones).
 Be careful when preparing soups and stews. The weight of the cooking vessel and the
contents together must not exceed 10 kg.
3. Press the On/Off button (10) to switch the hotplate on. The display (7) reads “1000”.
4. Press the function
button (12) to sh
ow the temperature.
When it is running, the cooler fan is also running and the hotplate can hum slightly when
cooking. This is not a malfunction.
5. Use the rotary controller (11) to set the power required in Watts or press the function key (12) to
display the cooki
ng temperature on the display (7) and adjust it using the rotary contro
ller (11).
Risk
of burns!
Do not touch the contact surface a cooking vessel has previously been standing on. After the
cooking vessel is removed, the cooking surface can still be very hot.
Use the function key (12) to switch betwe
en the power (5) and the temperature display
(6). However, please note that when you switch over, the power is always set to 1000 W and

Silvercrest SIKP 2000 D1 Specifications

General

Brand	Silvercrest
Model	SIKP 2000 D1
Category	Hob
Language	English