SilverCrest SIKP 2000 D1
20 - English
the temperature to 120 °C, irrespective of what it was set to before. So you need to make
sure your food does not burn.
Risk of fire!
Oil and fat can catch fire if over-heated. Therefore, be careful when heating oil and fat.
Never leave hot oil or fat unattended.
Risk of explosion! Never attempt to extinguish burning oil or fat with water. Instead,
smother it by covering the cooking pan with a well-fitting lid or plate. Unplug the mains
plug from the wall socket.
6. Prepare your food. While you are cooking, set the power or temperature you want using the rotary
controller (11).
7. When you are finished, switch off the induction hotplate. To do this, press the On/Off button
(10). A beeper then sounds and the display (7) shows "L" or "H" depending on the temperature.
Warning about property damage
The cooling fan runs for a while after you switch off. Do NOT remove the mains plug from the
wall socket while the cooling fan is still running.
If you switch the induction hotplate off and the surface temperature of the hotplate is
higher than 60 °C, "H" is shown on the display (7). If the temperature drops below
60 °C, the display (7) shows "L".
After approx. 2 hours of continuous operation the appliance switches off automatically
(even if you change any settings/display icons) and a beep can be heard. If you have
programmed the timer, the timer countdown will have priority and the appliance switches
off automatically after the set time.
7.3 Switching off using the timer
You can program the timer to switch the hotplate off automatically after a preset time.
1. Press the sensor button for the timer (9) when cooking with the hotplate to program the timer.
2. Use the rotary controller (11) to set the cooking time you want (hours:minutes) before the hotplate is
to switch off.
You can program the cooking time to between 00:00 to 3:00 hours.
The time set flashes briefly and then the remaining time (countdown) is shown on the display (7).
If the timer is activated, the indicator (4) lights up and alternates showing the power or temperature and
the remaining time at around 5 second intervals.
To Next Page
Loading...
Need help?
General
