1 INTRODUCTION
1.1. OVERVIEW
The SDM600 Series Radios are versatile Digital Signal Processor (DSP) controlled, two-
way mobile radios. The SDM600 Series is available in a number of frequency bands and
versions for specific applications. These Operating Instructions describe the operation
of the DMR Tier II Standard compliant Mobile Radio, consisting of an SDM600
Transceiver and SDM630 Control Head.
The radio is software programmable and it can be customised to the operational
requirements of your particular fleet. Your Simoco representative can help in
programming your radio facilities to meet your present and future requirements.
1.2. CONFIGURATION
The SDM630 Radio must be configured using the Field Personality Programmer (FPP)
prior to operation. The configuration process defines the radio channels, signalling
and other settings so that the radio will operate with your system.
1.3. INSTALLATION
As the installation of your SDM600 Transceiver is a technical and possibly hazardous
operation, we recommend that it is installed and set up for use by your dealer or an
authorised installer. However, if you need information regarding the correct
procedures for installation, please refer to the SDM600 Series Installation Guide [2]
supplied with the radio.
1.4. MODES OF OPERATION
The SDM630 Radio is capable of operation in Analogue Frequency Modulation (FM)
and DMR modes.
Radio Channels are organised in groups of up to 250 per zone. Up to 40 zones may be
defined.
Generally, zones can be programmed with channels belonging to common function
groups.
A radio channel can be defined as either Analogue or DMR, and a Zone may contain a
mix of Analogue or DMR Channels.
Doc Number: TNM--U-E-0108 ISSUE 1.5 Page 23
To Next Page
Loading...
Need help?
General
