en
23
Check Mower Blade Stopping Time
Check the mower blade for proper function (see Safety
Interlock System Tests). The blade should stop rotating in
5 seconds or less after moving the blade control to the OFF
position.
WARNING
If the mower blade does not come to a complete
stop within 5 seconds, the clutch must be adjusted. Do not
operate the machine until the proper adjustment has been
performed by an authorized dealer.
Cleaning the Battery and Cables
B
C
A
Figure 9
1. Disconnect the cables from the battery, negative
cable rst (A, Figure 9).
2. Remove the battery hold-down strap (B) and battery.
3. Clean the battery compartment with a solution of
baking soda and water.
4. Clean the battery terminals and cable ends with a wire
brush and battery terminal cleaner until shiny.
5. Reinstall the battery in the battery compartment, and
secure with the battery hold-down strap.
6. Reattach the battery cables, positive cable rst (C).
7. Coat the cable ends and battery terminals with
petroleum jelly or non-conducting grease.
A dead battery or one too weak to start the engine may
be the result of a defect in the charging system or other
electrical component. If there is any doubt about the cause
of the problem, see your dealer. If you need to replace the
battery, follow the steps under Cleaning the Battery and
Cables.
To charge the battery, follow the instructions provided by
the battery charger manufacturer as well as all warnings
included in the safety rules sections of this book. Charge
the battery until fully charged. Do not charge at a rate
higher than 10 amps.
WARNING
When removing or installing battery cables, disconnect
the negative cable FIRST and reconnect it LAST. If not done in
this order, the positive terminal can be shorted to the frame by
a tool.
WARNING
Keep open flames and sparks away from the battery;
the gasses coming from it are highly explosive. Ventilate the
battery well during charging.
Battery Charging
To Next Page
Loading...
Need help?
General
