Simplicity 6 User Manual

Attaching the lighting to the Simplicity 6 wall plate:
To do this drill a hole through the back of the light channel (facing the wall) in the desired location
for cable exit using a 6mm drill bit, crimp the cables to the red and black LED cables exiting the
light channel and feed the extended cables through the hole and run them into the building or the
plastic external box supplied and connect them to the capacitor. Then slide the polycarbonate lens
back into the light and screw the end cap back on to the light channel. The capacitor will then need
to be powered to the mains either via a fused spur or a plug socket as per the specification
detailed on the lighting capacitor.
End.
16

Simplicity 6 Specifications

General

Brand	Simplicity
Model	6
Category	Tiller
Language	English