10
SIMPLICITY CUSTOM STITCH SELECTION
The upper thread tension dial controls the amount of needle
thread delivered to the bobbin case. Most thread tension
adjustments should be made using the upper thread ten-
sion dial. In some cases, the lower thread tension on the
bobbin case may need to be adjusted for specialty
sewing techniques.
UPPER THREAD TENSION
The numbers 0-9 on the dial represent upper thread
tension settings. The higher the number, the stronger the
upper tension.
Tension settings between 3-5 are most
commonly used [Fig. 1]. In a balanced stitch, needle
thread and bobbin thread interlock in the center of the
two fabric layers [Fig. 2]. If needed, adjust an unbalanced
stitch by turning the dial until the new setting is aligned
with the indicator line on the machine [Fig. 1].
If the fabric gathers or the threads break, the upper thread
tension is too tight [Fig. 3]. Loosen the tension by moving
the dial to a lower number.
If loops form on the top side of the seam then the upper
tension is too loose [Fig. 4]. Tighten the upper tension by
turning the dial to a higher number.
LOWER THREAD TENSION
The lower thread tension can be adjusted by turning the
screw on the bobbin case slightly to the right (clockwise)
to increase the tension [Fig. 5]. Turn the tension slightly to
the left (counterclockwise) to decrease the tension [Fig. 6].
TENSION ADJUSTMENTS
Fig. 1
Fig. 3
Fig. 4
Fig. 5
Fig. 6
Increase tension
Decrease tension
F
ig. 2
R
ANGE STITCH PATTERN
S
TITCH
S
TITCH
P
RESSER
D
ROP
WIDTH LENGTH FOOT FEED
N A Straight 0 0-4 All feet Up/Down
N A
Zigzag 1-5 0-4 All-purpose Up/Down
N B
Knit blindhem 3-5 4 Blind hem Up
N C
3-step zigzag 3-5
3 All-purpose Up
N D Double action 3-5 3-4 All-purpose Up
N E
Woven blind hem 3-5 4 Blind hem Up
N F,G,H,I Decor
ative 3-5 2-4 Open toe Up
N J,K,L Buttonhole 3-5 0-1 Buttonhole Up
S A Triple stretch straight 0 3-4 All-purpose Up
S A Rick rack 2-5 2-4 All-purpose Up
S B Arrowhead 3-5 3 All-purpose Up
S C Honeycomb 3-5 2-4 All-purpose Up
S D Overcasting 3-5 3-4 Overcast Up
S E Elastic overlock 3-5 3-4 All-purpose Up
S F,G,H,I Decorative 3-5 2-4 Open toe Up
Upper thread too tight
Upper thread too loose
To Next Page
Loading...
Need help?
General
