20
Return-to-Neutral Adjustment
Perform the following adjustment if the shift lever
does not return to the neutral gate when the clutch/
brake pedal is fully depressed.
1. Make sure the Neutral Adjustment is correct
(refer to preceding paragraph).
2. Loosen the nut (A, figure 6-3) that secures the
rear shift rod (B) to the return-to-neutral cam (C).
3. Hold the clutch/brake pedal fully down against
the right footrest. Pedal can be clamped in this
position with large C-clamp if required. Do not
apply parking brake as pedal will not be held
against footrest without free play.
4. Rotate the return-to-neutral cam (C) securely
against the front clutch rod (D). There should be
no gap between the clutch rod and cam.
5. Tighten nut (A) with pedal held down against
footrest.
6. Start tractor and check return-to-neutral opera-
tion. With pedal released, a small amount of
travel in the shift lever may be required to fully
stop tractor.
Figure 6-3. Return-to-Neutral Adjustment
A. Nut C. Return-to-Neutral Cam
B. Rear Shift Rod D. Front Clutch Rod
Section 6. (Continued)
Tractors with HydroGear 311-0750/311-0800 Transaxle
To Next Page
Loading...
Need help?
General
