To Next Page

To Previous Page

Unclogging the Nozzle and Hose

WARNING! To Reduce the Risk of Electrical

Shock or Injury From Moving Parts, Unplug

Before Servicing or Cleaning.

The hose located on the back of the vacuum

carries the dirt from the nozzle to the

vacuum bag. The hose also functions as the

attachment cleaning hose. First check to see

that a bag is properly installed.

If the Hose Becomes Clogged

There are three areas to check if you

suspect a clog in the hose:

Suction Dial

• Turn the Suction Dial to the open position.

Remove the clog or blockage (Fig. 1).

Nozzle Inlet Tube

• Turn the vacuum over and remove the

bottom plate (See page 18). Check the

nozzle inlet tube for obstructions (Fig. 2).

Clear the tube and reinstall the bottom plate.

Nozzle Hose

• Turn the vacuum over and remove the

bottom plate (See page 18). Remove one

screw at the base of the nozzle hose (Fig. 3).

Clear the hose of blockage and replace the

screw. Reinstall the bottom plate.

Inlet Tube

Screw

Fig. 1

Fig. 2

Fig. 3

MAIntenAnCe AnD CARe

Simplicity Symmetry S20S User Manual

Questions and Answers: