26
Troubleshooting
In this troubleshooting guide you will nd solutions to the problems you may have with your machine. For further
information please go to www.singer.com.
Problem/Cause Remedy
General Problems
Fabric does not move? Make sure that the feed teeth are not lowered.
The needle breaks? Insert needle correctly, see page 15.
Attach correct needle for the fabric.
The machine will not sew? Check that all plugs are securely plugged into the
machine and into the wall socket.
Push bobbin winder lever to sewing position.
The sewing machine function buttons do not respond to
touch?
The sockets and function buttons on the machine can be
sensitive to static electricity. If the buttons do not respond
to touch, turn the machine OFF and then ON again. If the
problem persists, go to www.singer.com for information
on locating an authorized service center.
The Machine Skips Stitches
Did you insert the needle properly? Insert needle correctly, see page 15.
Did you insert a wrong needle? Insert correct needle. See Stitch Reference Guide at
www.singer.com
Is the needle bent or blunt? Insert a new needle.
Did you thread the machine properly? Check how the machine is threaded.
Is the correct presser foot used? Attach correct presser foot.
Is the needle too small for the thread? Make sure the needle is correct for the thread and fabric.
Needle Thread Breaks
Did you insert the needle properly? Insert needle correctly, see page 15.
Did you insert a wrong needle? Insert correct needle. See Stitch Reference Guide at
www.singer.com
Is the needle bent or blunt? Insert a new needle.
Did you thread the machine properly? Check how the machine is threaded.
Is the needle too small for the thread? Change the needle to the proper size for the thread.
Are you using poor thread with slubs or thread which
has become dry?
Change to a new thread with a smooth, even lament.
Is a correct spool cap used? Attach a spool cap of the right size for the actual thread
spool.
Is the best spool pin position used? Try a different spool pin position (vertical or horizontal).
Is the stitch plate hole damaged? Change the stitch plate.
Bobbin Thread Breaks
Did you insert the bobbin properly? Check the bobbin thread.
Is the stitch plate hole damaged? Change the stitch plate.
Is the bobbin area clean? Clean lint from bobbin area.
Is the bobbin wound correctly? Wind a new bobbin.
To Next Page
Loading...
Need help?
General
