Singer MX60 User Manual

6
Winding the Bobbin
- Place the thread and spool pin felt (a) onto the spool pin. (1)
- Draw the thread from the spool through the upper thread
guide. (2)
- Wind the thread clockwise around bobbin winder tension
discs. (3)
- Thread bobbin as illustrated and place on spindle. (4)
- Push bobbin spindle to right. (5)
- Hold thread end. (6)
- Step on foot control pedal. (7)
- Release the pedal after a few turns. Release the thread
and cut as close as possible to the spool. Press the pedal
again. Once the spool is full, it rotates slowly. Release the
pedal and cut thread. (8)
- Push bobbin spindle to left (9) and remove.
Please Note:
When the bobbin winder spindle is in “bobbin winding”
position, the machine will not sew and the hand wheel will
not turn. To start sewing, push the bobbin winder spindle
to the left (sewing position).
a
Threading the Machine

Singer MX60 Specifications

General

Buttonhole Type	4-step
Free Arm	Yes
Type	Mechanical
Buttonhole Styles	1
Needle Threader	Yes
Max Stitch Length	4mm
Max Stitch Width	5mm
Stitch Options	Straight, zigzag, buttonhole
Presser Feet	Buttonhole, zipper