Singer MX60 User Manual

16
Install the darning plate. (1)
Position the work under the foot.
Place the button in the desired position and lower the foot.
Set the Pattern Selector Dial for the second zig-zag pattern
(as shown), which should correspond to the distance between
the two holes of the button. Turn the handwheel toward you
to check if the needle goes into the right and left hole of the
button without hitting the button. Slowly sew on the button
with about 10 stitches. (2)
Bring the thread tails to the back of the work, then tie o󰀨
manually.
If a shank is required, place a darning needle on top of the
button and sew. (3)
For buttons with 4 holes, sew through the front two holes
rst, push the work forward and then sew through the back
two holes.
Sewing on Buttons

Singer MX60 Specifications

General

Buttonhole Type	4-step
Free Arm	Yes
Type	Mechanical
Buttonhole Styles	1
Needle Threader	Yes
Max Stitch Length	4mm
Max Stitch Width	5mm
Stitch Options	Straight, zigzag, buttonhole
Presser Feet	Buttonhole, zipper