SKY-WATCHER EQ6-R MOUNT User Manual

5
1.4 Installing the Counterweights
1. Loosen the knob for locking the counterweight rod and gently pull out the counterweight
rod. Re-tighten the knob to secure the counterweight rod in place. (Fig. 1.4a)
2. Loosen the R.A. clutch with the lever, and rotate the R.A. Axis until the counterweight rod
is pointing towards the ground. (Fig. 1.4b)
3. Remove the threaded cap from the end of the counterweight rod.
4. The EQ6-R mount comes with a 290mm counterweight rod extension, which can be in-
stalled at this point if necessary. Ensure the extension is tightly secured before installing
counterweights. (Fig. 1.4c)
5. Loosen the counterweight’s thumb screw and slide the counterweight onto the counter-
weight rod. Re-tighten the thumb screw to secure the counterweight on the rod.
6. Replace the cap to the end of the counterweight rod.
Fig. 1.4b
Fig. 1.4c
Fig. 1.4a
Fig. 1.4d
1.5 Installing the Telescope
1. Before installing a telescope, ensure:
• The counterweight rod is pointing towards the ground.
• All counterweights have been moved to the end of the counterweight rod.
• The R.A. Axis is secured by tightening the R.A. Clutch.
PART I: SETTING UP THE EQ6-R MOUNT
1
2
R.A.
Clutch
Lever
Lock
Loosen
Locking Knob
Thumb
Screw

SKY-WATCHER EQ6-R MOUNT Specifications

General

Brand	SKY-WATCHER
Model	EQ6-R MOUNT
Category	Camera Accessories
Language	English