SMC Networks EZ Connect SMC2870W User Manual

9
EZ I NSTALLATION W IZARD
To configure your SMC2870W, first verify that your computer has
an IP address in the same subnet as the SMC2870W. If you are
not familiar with this procedure, see the “Using IPCONFIG”
section below.
Note: The default IP address of the SMC2870W is 192.168.2.25.
1. Insert the SMC EZ Installation Wizard & Documentation CD
into your CD-ROM drive.
2. The EZ Installation Wizard will appear. Click “Configuration
Utility” to begin the utility installation and setup process.
Using IPCONFIG
1. Click the “Start” button, click “Run” and type “command.”
2. Press “OK” and a DOS command prompt will appear.
3. Type “ipconfig” and press enter.
4. Verify that your IP address is 192.168.2.xxx. If so, you can
now use the SMC EZ Installation Wizard to configure your
SMC2870W. If your IP subnet is different, please go to the
“Configuring Your IP Address” on page 23.

SMC Networks EZ Connect SMC2870W Specifications

General

Brand	SMC Networks
Model	EZ Connect SMC2870W
Category	Network Router
Language	English