EZ Switch 10/100
6
TROUBLESHOOTING
1. Symptom
Power LED does not light after powering on the
switch.
Probable Causes
Power outlet or power cord may be defective.
Possible Solutions
• Check for loose connections.
• Check the power outlet by using it with another
device.
• Replace the power cord.
2. Symptom Link
LED does not light after a connection is made.
Probable Causes
Switch port, network card or cable may be defective.
Possible Solutions
• Check that the Switch and attached device are
both powered on.
• Be sure the network cable is connected to both
devices.
• Verify that Category 5 cable is used for 100 Mbps
connections and that the length of any cable does
not exceed 100 meters (328 feet).
• Check the network card and cable connections
for defects.
• Replace the defective card or cable if necessary.
To Next Page
Loading...
Need help?
General
