SMC Networks PF2W7 Series User Manual

-20-
No.PF※※-OMO0012-D
Outline of setting
Power is supplied
The output will not operate for 3 seconds after supplying power.
The identification code of the product is displayed.
Measurement mode
The mode in which the flow is detected and displayed, and the switch function is operating.
This is the basic operating mode; and other modes should be selected for setting
changes and other function settings.
The display of instantaneous flow and accumulated flow can be changed
while the button is pressed.
While pressing the button during the display of accumulated flow,
the accumulation can be started/stopped by pressing the button.
button
press
for 2 sec.
button
press.
button
press
for 3 sec.
Initialize mode
(Refer to page 22)
Items below can be set.
Display mode
Unit selection function

Output mode (OUT1)
Output mode (OUT2)
Switch operation (OUT1)
Switch operation (OUT2)
Function selection
mode
(Refer to page 26)
Items below can be set.
[F_1]
Input the Set value of
instantaneous output
[F_2]
Input the Set value of
instantaneous output
(Auto-preset)
[F_3]
Input the Set value of
accumulated output
Key-lock function
(Refer to page 31)
This function is used to
prevent errors occurring
due to unintentional
changes of the Set
values.
: Operate only the product with unit selection function.

SMC Networks PF2W7 Series Specifications

General

Brand	SMC Networks
Model	PF2W7 Series
Category	Switch
Language	English