Snap-On ATECH2FM100 User Manual

11
Note: Pressing ENTER   button while EXIT menu selection is highlighted will exit without deleting
PSET.
Note: When a PSET is deleted, all other stored PSET’s will retain their original PSET numbers. When a
new PSET is entered, it will be assigned first available PSET number in sequence.
 Advanced Settings
Accessing Advanced Settings
Advanced settings are accessed from SETTINGS menu selection on main menu.
1. From target torque or angle screen, press and hold ENTER   button for 3 seconds.
2. Highlight SETTINGS menu selection using UP   /DOWN  buttons.
3. Press ENTER   button to display Settings menu.
Menu Selections:
 EXIT - Exits Settings menu and returns to target screen.
 SHOW INFO - Displays wrench operational information.
 SLEEP TIME - Displays power down interval setup screen.
 LCD CONTRAST - Displays LCD contrast setup screen.
 KEY BEEP - Displays button press beep enable/disable setup screen.
 AUTO BACKLIGHT - Displays auto backlight enable/disable screen to turn on backlight during
measurement.
 TOGGLE BACKLGHT - Displays BACKLIGHT button toggle or timeout enable/disable
screen.
 VIBRATOR CONFIG - Displays vibrator ON/OFF configuration for when target reached.
 BATTERY TYPE – Displays the battery type selection screen.
4. To exit Settings menu and return to target torque or angle screen, press ENTER   button while
EXIT menu selection is highlighted.
Note: All user configurable settings are stored in non-volatile memory and are retained while power
is off.
ENTER button
UNIT
button
held
Target Torque Screen
UP/DOWN buttons
ENTER button
Preset Angle Screen
PSET 02 00
92°
DELETE
EDIT
EXIT
DELETE
EDIT
EXIT
00
100.0 IN-LB
UP/DOWN buttons
ENTER
button
held
Target Screen
ENTER
button
00
100.0 IN-LB
EXIT
SET HEAD LENGTH
SHOW DATA
CYCLE COUNT
LANGUAGE
SETTINGS
EXIT
SHOW INFO
SLEEP TIME

Snap-On ATECH2FM100 Specifications

General

Brand	Snap-On
Model	ATECH2FM100
Category	Power Tool
Language	English