Snap-On TECHANGLE ATECH3FR300B User Manual

8
Viewing and Clearing Wrench Cycle Counter
Each time torque or angle target is reached, wrench cycle counter is incremented. Maximum cycle
count is 999999.
1. From target torque or angle screen, press and hold ENTER   button for 3 seconds.
2. Highlight CYCLE COUNT menu selection using UP   /DOWN   buttons.
3. Press ENTER   button to display CYCLES screen.
4. To exit CYCLE COUNT screen without clearing count, press ENTER   button while EXIT menu
selection is highlighted.
5. To reset wrench cycle count to 0, highlight CLEAR menu selection then press ENTER   button.
6. EXIT menu selection is automatically highlighted after count is cleared. Press ENTER   button to
return to main menu.
Language
1. From target torque or angle screen, press and hold ENTER   button for 3 seconds.
2. Highlight LANGUAGE menu selection using UP   /DOWN   buttons.
3. Press ENTER   button to display LANGUAGE selection screen.
4. Highlight desired language using UP   /DOWN   buttons and press ENTER   button.
5. Decimal Mark selection menu is displayed. Decimal separator can be a comma or decimal point.
Use UP   /DOWN   buttons to select decimal separator then press the ENTER   button.
6. To exit Main menu and return to target torque or angle screen, press ENTER   button while EXIT
menu selection is highlighted.
00
M
100.0
FT-LB
EXIT
SET HEAD LENGTH
SHOW DATA
CLEAR DATA
EXIT
SET HEAD LENGTH
SHOW DATA
M
CLEAR DATA
EXIT
SET HEAD LENGTH
SHOW DATA
M
CLEAR DATA
CLEAR ALL DATA
YES
M
NO
CLEAR ALL DATA
YES
M
NO
EXIT
SET HEAD LENGTH
SHOW DATA
M
CLEAR DATA
ENTER
button
held
Target Screen
ENTER
button
UP/DOWN buttons
UP/DOWN buttons
ENTER
button
ENTER
button
SET HEAD LENGTH
SHOW DATA
CLEAR DATA
M
CYCLE COUNT
00
M
100.0
FT-LB
COUNT: 12
CLEAR
M
EXIT
COUNT: 12
CLEAR
M
EXIT
SET HEAD LENGTH
SHOW DATA
CLEAR DATA
M
CYCLE COUNT
EXIT
SET HEAD LENGTH
SHOW DATA
M
CLEAR DATA
ENTER
button
held
Target Screen
ENTER
button
UP/DOWN buttons
UP/DOWN buttons
ENTER
button
ENTER
button
COUNT: 0
CLEAR
M
EXIT
ENTER button
ENTER
button
Target Screen
Decimal Mark Selection menu
DECIMAL MARK
COMMA (1,23)
POINT (1.23)
ENTER
button
UP/DOWN buttons
DECIMAL MARK
COMMA (1,23)
POINT (1.23)
00
100,0
FT-LB
00
100.0
FT-LB
EXIT
SET HEAD LENGTH
SHOW DATA
CLEAR DATA
ENTER
button
held
ENGLISH
FRANCAIS
ESPANOL
DEUTSCH
ENTER
button
Language Selection
menu
SHOW DATA
CLEAR DATA
CYCLE COUNT
LANGUAGE
UP/DOWN buttons

Snap-On TECHANGLE ATECH3FR300B Specifications

General

Brand	Snap-On
Model	TECHANGLE ATECH3FR300B
Category	Power Tool
Language	English