20
Regular
Maintenance
MAINTENANCE SCHEDULE & PROCEDURES
The following schedule should be followed for normal care of your rider and mower.
* Refer to engine owner’s manual. Change original engine oil after initial break-in period.
** More often in hot (over 85° F: 30° C) weather or dusty operating conditions.
*** Service after the first 50 hours of operation, then every 250 hours of operation.
**** Service after the first 25 hours of operation, then every 250 hours of operation.
***** See you dealer.
Tire Pressure
Front 10-12 psi (,68 - ,82 bar)
Rear 10-12 psi (,68 - ,82 bar)
Figure 9. Checking Tire Pressure
CHECK TIRE PRESSURES
Tire Pressure should be checked periodically, and main-
tained at the levels shown in the chart. Note that these
pressures may differ slightly from the “Max Inflation”
stamped on the side-wall of the tires. The pressures
shown provide proper traction, improve cut quality, and
extend tire life.
SAFETY ITEMS Before
Each
Use
Every 5
Hours
Every 25
Hours
Every
100
Hours
Every
250
Hours
Spring
& Fall
Check Safety Interlock System •
Check Tractor Brakes •
Check Mower Blade Stopping Time • •
TRACTOR MAINTENANCE ITEMS Before
Each
Use
Every 5
Hours
Every 25
Hours
Every
100
Hours
Every
250
Hours
Spring
& Fall
Check Tractor/Mower for loose hardware •
Lubricate Rear Axle Shafts Yearly
Clean Battery & Cables •
Check Tire Pressure •
Clean Deck & Check/Replace Mower Blades** •
Lubricate Rider & Mower • ***
Transmission Maintenance *****
ENGINE MAINTENANCE ITEMS Before
Each
Use
Every 5
Hours
Every 25
Hours
Every
100
Hours
Every
250
Hours
Spring
& Fall
Check Engine Oil Level •
Check / Change Engine Air Filter *
Change Engine Oil & Filter *
Inspect Spark Plug(s) *
Check / Replace Fuel Filter *
To Next Page
Loading...
Need help?
General
