About This Guide
This user guide is intended for Photovoltaic (PV) system owners,
installers, technicians, maintainers and integrators who use the
SolarEdge power harvesting system.
This manual describes how to install and set up the ZigBee™
communication between a SolarEdge device (inverters or Safety and
Monitoring Interface) and the SolarEdge home ZigBee repeater). The
manual instructions and graphics refer to the inverter; however
apply to SMI as well.
This guide assumes that the SolarEdge power harvesting system is
already installed and commissioned. For additional information
about how to install and commission the SolarEdge power harvesting
system, refer to the relevant installation guide.
The guide includes the following chapters:
Chapter 1: Introducing the SolarEdge ZigBee Repeater, page 6,
describes the SolarEdge ZigBee repeater functionality and
connection.
Chapter 2: SolarEdge Repeater User Interfaces, page 8,
describes the repeater connectors and LEDs.
Chapter 3: Installing the Repeater, page 10, describes how to
mount, connect, and verify the connection of the SolarEdge
repeater.
Appendix A: Technical Specifications page 14, provides the
electrical and mechanical specifications of the SolarEdge ZigBee
repeater.
For further information, datasheets and the most up-to-date
certifications for various products in different countries, please visit
the SolarEdge website: www.solaredge.com
To Next Page
Loading...
Need help?
General
