Sony BDP-S380 User Manual

22
=> The disc has a format that cannot be played
back by this player (page 24).
=> The player cannot play a recorded disc that
is not correctly finalized.
=> The region code on the BD or DVD does
not match the player.
‘USB device othe alah a Bees
MRNA EED cine eae!
The player does not detect a USB device
connected to the player.
=> Make sure that the USB device is securely
connected to the USB jack.
=> Check if the USB device or a cable is
damaged.
= Check if the USB device is on.
> If the USB device is connected via a USB
hub, connect the USB device directly to the
player,
W i paia n a S
The picture/sound is poor/certain
programs display a loss of detail,
especially during fast-motion or dark
scenes.
=> Picture/sound quality may be poor
depending on Internet content providers.
=> Picture/sound quality may be improved by
changing the connection speed. We
recommend a connection speed of at least
2.5 Mbps for standard definition video
(10 Mbps for high definition video).
= Not all videos will contain sound.
The picture is small.
=> Press # to zoom in.
The player cannot connect to the network.
=> Check the network connection (page 12)
and the network settings (page 20).
The message [A new software version is
available. Please go to the “Setup”
section of the menu and select “Network
update” to perform the update.] appears
on the screen when turning the player on.
=> See [Network Update] (page 16) to update
the player to a newer software version:
The [Control for HDMI] function does not
work (BRAVIA Sync).
=> Check that (Control for HDMI] is set to
[On] (page 19).
=> If you change the HDMI connection, turn
the player off and on again.
=> If power failure occurs, set [Control for
HDMI] to [Off], then set (Control for
HDMI] to [On] (page 19).
=> Check the following and refer to the
instruction manual supplied with the
component.
~ the connected component is compatible
with the [Control for HDMI] func
~ the connected component's setting for
the [Control for HDMI] function is
correct
= When you connect the player toa TV
through an AV amplifier (receiver),
— if the AV amplifier (receiver) is not
compatible with the [Control for HDMI]
function, you may be unable to control
the TV from the player.
if you change the HDMI connection,
disconnect and reconnect the AC power
cord, or a power failure occurs, try the
following: @Switch the input selector of
the AV amplifier (receiver) so that the
picture from the player appears on the
TV screen. @Set [Control for HDMI] to
[Off], then set (Control for HDMI] to
[On] (page 19), Refer to the instruction
manual supplied with the AV amplifier
(receiver).
je System Power-Off function does not
work (BRAVIA Sync).
=> Check that [Control for HDMI] and
[HDMI: Linked to TV-off] are set to [On]
(page 19).
Si H ait)
Playback does not start from the
beginning of content.
=> Press OPTIONS, and select [Play from
beginning}.
Playback does not start from the resume
point where you last stopped playing.
=> The resume point may be cleared from
memory depending on the disc when
— you open the disc tray.
— you disconnect the USB device.
— you play other content.
— you turn off the player.
The disc tray does not open and es
“LOCKED” or “TLK ON” appears on the
front panel display.
=> When “LOCKED” appears, the player is
locked. To cancel the Child Lock, hold
down B on the player until “UNLOCK”
appears on the front panel display (page 7).
=> When “TLK ON” appears, contact your
Sony dealer or local authorized Sony
service facility.
The disc tray does not open and you
cannot remove the disc even after you
press &.
=> Try the following: ©Turn the player off,
and disconnect the AC power cord.
@Reconnect the AC power cord while
pressing down & on the player. @Keep
pressing down & on the player until the tray
‘opens. @Remove the disc. ©When
“OPEN” appears on the front panel display,
hold down U/C} on the player for more than
10 seconds until the player turns off.
“Exxxx” or “TEM ERR” appears on the
front panel display.
= When “Exxxx” appears, contact your
nearest Sony dealer or local authorized
Sony service facility and give the error
code.
= When “TEM ERR" appears, place the
player in a location with adequate
ventilation to prevent heat build-up in the
player.
The player does not respond to any button.
=> Moisture has condensed inside the player
(page 3).
= Hold down UO on the player for more than
10 seconds until the indicators on the front
panel display turn off.
If the player still does not respond to any
button, disconnect then reconnect the AC
power cord.
Specifications
System
Laser: Semiconductor laser
Inputs and outputs
(Jack name:
Jack type/Output level/Load impedance)
LINE OUT R-AUDIO-L:
Phono jack/2 Vrms/10 kilohms
DIGITAL OUT (COAXIAL):
Phono jack/0.5 Vp-p/75 ohms
HDMI OUT:
HDMI 19-pin standard connector
COMPONENT VIDEO OUT (Y, Pa, Pr):
Phono jack/Y: 1.0 Vp-p/
Pu, Pr: 0.7 Vp-p/75 ohms
LINE OUT VIDEO:
Phono jack/1.0 Vp-p/75 ohms
LAN (100)
100BASE-TX Terminal
USB:
USB jack Type A (For connecting a USB
memory, memory card reader, digital still
camera, and digital video camera)
uonewsojuj jeuonippy |
General
120V AC, 60Hz
Models for other areas:
110-240V AC, 50/60Hz
See page 3 for further information.
Power consumption:
18 W
Dimensions (approx.):
430 mm x 199 mm x 36 mm
(17 in. x 7 4/5 in, x 1 7/16 in.)
(width/depth/height) incl. projecting parts
Mass (approx.
6 kg (3 Ib 9 oz)
Operating temperature:
5°C to 35 °C (41 °F to 95 °F)
Operating humidity:
25 % to 80 %
Supplied accessories
* Audio/video cable (phono plug x3) (1)
* HDMI cable (1) (BDP-BX38 for U.S.
models only)
* Remote commander (remote) (1)
* Size AA (R6) batteries (2)
A plug adaptor is included with some models.
Specifications and design are subject to
change without notice.
continued 23

Sony BDP-S380 Specifications

General

HDMI	Yes
Aspect ratio	16:9
Product color	Black
Dimensions (WxDxH)	430 x 199 x 36 mm
Power requirements	60Hz, 120V
Composite video out	1
USB 2.0 ports quantity	2
Power consumption (typical)	18 W