Recording
Recording
33
Searching for the last
scene of the most
recent recording
– END SEARCH
This function is handy when you have played
back the tape, for example, but want to start
recording right after the most recently
recorded scene. The END SEARCH function
will not work once you eject the cassette after
you have recorded on the tape.
1 Slide the POWER switch to select the
CAMERA mode.
2 Press END SEARCH.
The last scene of the most recent recording
is played back for about 5 seconds, and the
camcorder enters the standby mode at the
point where the last recording has finished.
To cancel the operation
Press END SEARCH again.
b Note
• The END SEARCH function will not work correctly
when there is a blank section between recorded
sections on the tape.
z Tip
• When PLAY/EDIT mode is selected, you can do this
operation by pressing END SEARCH.
END SEARCH
POWER
switch
To Next Page
Loading...
Need help?
General