Getting started
12
Step 2: Charging the
battery pack
You can charge the battery by attaching the
“InfoLITHIUM” battery pack (M series)
to your camcorder.
b Notes
• You cannot use batteries other than the
“InfoLITHIUM” battery pack (M series) (p. 83).
• Do not short-circuit the DC plug of the AC Adaptor
or battery terminals with any metallic objects. This
may cause a malfunction.
• Use a nearby wall outlet when using the AC
Adaptor. Disconnect the AC Adaptor from the wall
outlet immediately if any malfunction occurs.
1 Lift up the viewfinder.
2 Attach the battery pack by sliding it in
the direction of the arrow until it
clicks.
3 With the v mark on the DC plug
facing up, connect the AC Adaptor to
the DC IN jack on your camcorder.
4 Connect the power cord to the AC
Adaptor.
5 Connect the power cord to the wall
outlet.
6 Slide the POWER switch up to (CHG)
OFF.
The CHG (charge) lamp lights up and
charging starts.
To the wall outlet
DC plug
DC IN jack
Power cord
AC Adaptor
Battery pack
v mark
To Next Page
Loading...
Need help?
General