82
Identifying the parts
%¢ Built-in light (CCD-TRV93 only) (p. 52)
%∞ LIGHT switch (CCD-TRV93 only) (p. 52)
%§ MIC jack (PLUG IN POWER)
Connect an external microphone (not
supplied). This jack also accepts a
“plug-in-power” microphone.
%¶ Camera recording/battery lamp (p. 11)
%∞
%§
%¶
%•
^º
%¢
%ª
%• LASER LINK emitter (p. 56)/Nightshot
Light emitter (p. 36)
%ª Remote sensor (p. 83)
Aim the Remote Commander here for
remote control.
^º Microphone
To watch the demonstration
You can start the demonstration by setting DEMO MODE in the menu system.
You can also start the demonstration by the following operation.
When NIGHTSHOT is set to ON, you cannot watch the demonstration.
To enter demo mode
(1) Eject the cassette and set the POWER switch to VTR.
(2) Turn STANDBY up to STANDBY.
(3) While holding down ( set the POWER switch to CAMERA.
To exit demo mode
(1) Set the POWER switch to VTR.
(2) Turn STANDBY up to STANDBY.
(3) While holding down p set the POWER switch to CAMERA.
To Next Page
Loading...
Need help?
General