14
GB
Printing
Operation During
Printing
Print paper moves back and
forth
During printing, the print paper passes
four times back and forth between the
paper exit slot and the top of the paper
tray. When printing is completed, the
paper is ejected from the paper exit
slot.
Notes
• Place the unit on a flat, level surface for
printing. If there is for example a raised
section or a wall behind the unit, paper
jams can occur.
• Before starting to print, make sure that
there are no obstructions behind the unit
which could block the smooth exit of the
paper. There should be a clearance of at
least 12 cm.
• Do not place any objects on top of the
paper tray.
• Do not touch the paper during printing, and
do not try to pull the paper out.
• Do not pull the paper tray out of the unit
during printing.
• Do not open the print cartridge door or
remove the print cartridge from the unit
during printing.
• Never move the unit during printing, and
do not turn off the power. Otherwise a
paper jam may occur or the unit may be
damaged. If the power was interrupted
during operation, turn the power on again
and repeat the procedure.
Print paper
Print cartridge door
To Next Page
Loading...
Need help?
General
