Sony DSX-M80 User Manual

Help Guide
Marine Audio
DSX-M80
Connecting with an iPhone/iPod (BLUETOOTH Auto Pairing)
When an iPhone/iPod with iOS5 or later installed is connected to the USB port, the unit is paired and connected with the
iPhone/iPod automatically. To enable BLUETOOTH Auto Pairing, make sure [AUTO PAIRING] in [BLUETOOTH] is set to
[ON].
Note
BLUETOOTH Auto Pairing is not possible if the unit is already connected to two BLUETOOTH devices. In this case, disconnect
one of the devices, then connect the iPhone/iPod again.
If BLUETOOTH Auto Pairing is not established, perform pairing and make the BLUETOOTH connection with the iPhone/iPod, as
with other BLUETOOTH device.
Related Topic
BLUETOOTH Setup (BLUETOOTH)
Preparing a Bluetooth® Device
Pairing and Connecting with a BLUETOOTH Device
Connecting with a Paired BLUETOOTH Device
5-006-644-11(1) Copyright 2019 Sony Corporation
Activate the BLUETOOTH function on the iPhone/iPod.
1
Connect the iPhone/iPod to the USB port.
Make sure that (BLUETOOTH) lights up on the display of the unit.
2
20

Sony DSX-M80 Specifications

General

Preamp Voltage	5V
Bluetooth	Yes
Tuner	AM/FM
Water Resistance	IPX5
Number of Channels	4
SiriusXM Ready	Yes
Marine Ready	Yes
Display Type	LCD
Remote Control	Yes
Display	LCD
USB	Yes
AUX Input	Yes
Compatible Audio Formats	MP3, WMA, AAC
Dimensions (W x H x D)	178mm x 50mm x 153mm
Pre-Out	3 Pre-Outs (5V)