Getting started
16
Step 2: Charging the
battery pack
You can charge the battery by attaching the
“InfoLITHIUM” battery pack (P series) to
your camcorder.
b Notes
• You cannot use batteries other than the
“InfoLITHIUM” battery pack (P series) (p. 128).
• Do not short-circuit the DC plug of the AC Adaptor
or battery terminals with any metallic objects. This
may cause a malfunction.
• Use a nearby wall socket when using the AC
Adaptor. Disconnect the AC Adaptor from the wall
socket immediately if any malfunction occurs.
1 Attach the battery pack by sliding it in
the direction of the arrow until it
clicks.
2 With the v mark on the DC plug facing
down, connect the AC Adaptor to the
DC IN jack on your camcorder.
3 Connect the mains lead to the AC
Adaptor.
4 Connect the mains lead to the wall
socket.
5 Slide the POWER switch up to OFF
(CHG).
To the wall socket
DC plug
DC IN jack
Mains lead
AC Adaptor
Battery pack
v mark
To Next Page
Loading...
Need help?
General