21
Getting Started
Step 2: Charging the battery pack
You can charge the “InfoLITHIUM”
battery pack (H series) (p. 108) after
attaching it to your camcorder.
b Notes
• You can use only the H series of
“InfoLITHIUM” battery pack with your
camcorder.
1 Slide the POWER switch in the
direction of the arrow to OFF
(CHG) (The default setting).
2 Raise the viewfinder, then attach
the battery pack by sliding it in
the direction of the arrow until it
clicks.
3 Connect the AC Adaptor to the
DC IN jack of your camcorder.
Open the jack cover, and connect the
DC plug of the AC Adaptor.
Match the v mark on the DC plug with
the v mark on your camcorder.
4 Connect the power cord to the AC
Adaptor and the wall outlet.
The CHG (charge) lamp lights up and
charging starts. The CHG (charge) lamp
turns off when the battery is fully
charged.
5 Disconnect the AC Adaptor from
the DC IN jack on your
camcorder.
b Notes
• Disconnect the AC Adaptor from the DC IN
jack holding both the camcorder and the DC
plug.
To the wall
outlet
Power cord
AC Adaptor
Battery
POWER switch
DC IN jack
CHG (charge)
lamp
DC plug
Jack cover
To Next Page
Loading...
Need help?
General