Sony HT-CT80 User Manual

11
GB
Getting Started
Installing the Bar
Speaker on a wall
You can mount the Bar Speaker on a
wall.
• Prepare screws (not supplied) that are
suitable for the wall material and
strength. As a plasterboard wall is
especially fragile, attach the screws
securely to two studs in the wall beam.
Install the Bar Speaker horizontally, hung
by screws in studs in a continuous flat
section of the wall.
• Be sure to subcontract the installation to
Sony dealers or licensed contractors and
pay special attention to safety during the
installation.
• Sony shall not be held responsible for
accidents or damage caused by improper
installation, insufficient wall strength,
improper screw installation or natural
calamity, etc.
1 Prepare screws (not supplied) that
are suitable for the holes on the
rear of the Bar Speaker.
2 Fasten the screws to 2 studs in the
wall.
The screws should protrude by
9 mm to 10 mm.
3 Hang the Bar Speaker on the
screws.
Align the holes at the rear of the Bar
Speaker with the screws, then hang
the Bar Speaker on the two screws.
Notes
4 mm
More than 30 mm
4.6 mm
Hole on the rear of the Bar Speaker
9 mm
9mm to
10 mm
447 mm

Sony HT-CT80 Specifications

General

Manual	Yes
Output power	80 W
Apple docking compatibility	Not supported
Number of amplifier channels	2.1 channels
FM radio	No
Product color	Black
Audio formats supported	AAC, MP3, WAV, WMA
Audio decoders	Dolby Dual Mono, Dolby Digital
RMS rated power	- W
Audio output channels	- channels
Woofer diameter	130 mm
Subwoofer location	Separate
Cables included	Optical
HDMI ports quantity	0
USB 2.0 ports quantity	1
Connectivity technology	Wired & Wireless
Power consumption (standby)	0.5 W
Power consumption (typical)	21 W

Weight and Dimensions

Soundbar weight	2000 g
Subwoofer depth	296 mm
Subwoofer width	165 mm
Subwoofer height	243 mm
Subwoofer weight	2700 g
Main unit dimensions (WxDxH)	901 x 84 x 52 mm