17
GB
HT-RT3
4-587-771-21(1)
D:\NORM'S JOB\SONY HA\SO150044\HT-RT3\4587771211_GB
(CEK)\060SET.fm
masterpage:
Right
Using the setup display
You can set the following items with the menu.
Your settings are retained even if you disconnect the AC power cord (mains lead).
1 Press MENU to turn on the menu in the front panel display.
2 Press BACK///ENTER repeatedly to select the item and press ENTER to
select the setting you want.
3 Press MENU to turn off the menu.
The default settings are underlined.
Settings and Adjustments
Menu list
Menu items Function
“LVL >”
(Level)
“SUR.L”/“SUR.R”
(Surround left/right
speaker level)
“0.0 dB”
: Adjusts the sound level of the Surround
Speakers from –6.0 dB to +6.0 dB (0.5 dB interval).
Be sure to set “TTONE” to “ON” for easy adjustment.
“ATT”
(Attenuation
settings – Analog)
Distortion may occur when you listen to a device
connected to the ANALOG IN jack. You can prevent
distortion by attenuating the input level on the system.
“ON”: Attenuates the input level. The output level will
decrease at this setting.
“OFF”: Normal input level.
“DRC”
(Dynamic range
control)
Useful for enjoying movies at low sound volume. DRC
applies to Dolby Digital sources.
“ON”: Compresses sound in accordance with the
information contained in the content.
“OFF”: Sound is not compressed.
“TTONE”
(Test tone)
“ON”: The test tone is output from each speaker in
sequence.
“OFF”: Turns off the test tone.
“SPK >”
(Speaker)
“PLACE”
(Speaker
placement)
“STDRD”: Select this setting if you install the Bar Speaker
and the Surround Speakers in standard position.
“FRONT”: Select this setting if you install the Bar Speaker
and the Surround Speakers in front.
“SUR.L”/“SUR.R”
(Surround left/right
speaker distance)
“3.0 M”
: Adjusts the distance from the seating position to
the Surround Speakers from 1.0 meter to 6.0 meters.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
