• In the same way, after pixel conversion in the FPGA (IC001), the HDMI OUT signal is sent through CN223 to the
DIF-223 board where the HDMI OUT signal is converted to the HDMI format by the HDMI encoder (IC201), and
is then output to the HDMI OUT connector (CN202) on the rear panel.
• After pixel conversion (except for SD mode), analog video signals are transferred to CN223 on the HPR-50 board
and are input to the analog encoder (IC301) on the DIF-223 board to be encoded and D/A converted.
The converted composite signal is output to the VIDEO OUT connector (CN302) on the rear panel.
The converted S video signal is output to the S VIDEO OUT connector (CN301) on the rear panel.
Audio output signals
• Audio signals decoded in the Codec Chip (IC002) are sent through CN223 to the DIF-223 board. Then the audio
signals are input to the HDMI encoder (IC201) in which they are superimposed on video signals, and the
superimposed signal are output to the HDMI OUT connector (CN202) on the rear panel.
• Audio signals are also input to the audio chip (IC004) on the HPR-50 board, in which the audio signals are D/A
converted. Then the converted analog signals are output to the AUDIO OUT connector (CN402) on the rear panel.
HVO-500MD/HVO-550MD
3-6
To Next Page
Loading...
