27
• Synchro-recording cannot be done if the connecting cord is not an optical
cable, or if the cable is connected to the MIC (PLUG IN POWER) jack.
• You cannot manually change the recording mode or the recording level
during synchro-recording.
Recording without overwriting existing
material
If you wish to avoid overwriting the current contents of an MD, do
the following procedure. All new material will then be recorded from
the end of the current contents.
1 While the recorder is stopped, press ENTER.
2 Press <MENU, repeatedly until “REC-Posi” flashes in the
display, and then press ENTER.
3 Press <MENU, repeatedly until “From End” flashes in the
display, and then press ENTER.
To start recording from the current point
Select “From Here” in step 3.
<MENU,
ENTER
To Next Page
Loading...
Need help?
General
