18
Appendix
Message List
The following messages and indications may appear for this camera. Perform the following as necessary.
Lamp display
Screen display
Lamp Meaning and solution
When the power is turned on, the
STANDBY lamp and POWER
lamp are lit, flash together, or
flash alternately.
The SYSTEM SELECT switch or the BOTTOM switch is not set correctly.
Check the setting of each switch.
The STANDBY lamp is lit. If the camera is moved forcibly, or a finger or other object interferes with camera movement,
the camera’s built-in processor may fail to memorize the pan/tilt position.
Press the PAN-TILT RESET button of the infrared remote commander to reset the pan/tilt
position.
Message Meaning and solution
PRESET n:OK
(“n” is a preset position number
between 1 and 16)
This message appears for about 3 seconds when you store camera settings to POSITION
1 to 16.
The preset position number of the infrared remote commander is POSITION 1 to 6.
RECALL n:OK
(“n” is a preset position number
between 1 and 16)
This message appears for about 3 seconds when you read the camera settings stored in
POSITION 1 to 16.
The preset position number of the infrared remote commander is POSITION 1 to 6.
RESET n:OK
(“n” is a reset position number
between 1 and 16)
This message appears for about 3 seconds when you reset camera settings stored in
POSITION 1 to 16.
The preset position number of the infrared remote commander is POSITION 1 to 6.
ONE PUSH WB:OP During the white balance adjustment in the ONE PUSH white balance mode, this message
blinks on the screen.
ONE PUSH WB:OK When the white balance adjustment has been done correctly in the ONE PUSH white
balance mode, this message is lit on the screen.
ONE PUSH WB:NG When the white balance adjustment has failed in the ONE PUSH white balance mode, this
message blinks on the screen.
To Next Page
Loading...
Need help?
General
