The above instructions on the computer are provided as an example. For details, refer to the operating instructions supplied with
your computer. In addition, not all the computers are tested and found compatible with the above procedure and the procedure is
not applicable to home-built computers.
Up to 2 BLUETOOTH devices can be connected to the speaker at the same time. When one of the devices starts playing back
while playing back music on another device, the speaker switches the output and starts outputting the sound from the new device
(Multi-device connection).
Note
The pairing mode of the speaker is released after about 5 minutes and the
(BLUETOOTH) indicator flashes slowly. However,
when pairing information is not stored in the speaker, such as at the factory settings, the pairing mode is not released. If the
pairing mode is released before finishing the process, repeat from step
.
Once BLUETOOTH devices are paired, there is no need to pair them again, except in the following cases:
Pairing information has been deleted after repair, etc.
The speaker is already paired with 8 devices and another device is to be paired.
The speaker can be paired with up to 8 devices. If a new device is paired after 8 devices have already been paired, the device
that was paired earliest is replaced by the new one.
The pairing information with the speaker has been deleted from the BLUETOOTH device.
The speaker is initialized.
All pairing information will be deleted. If you initialize the speaker, it may not be able to connect your iPhone/iPod touch or
computer. In this case, erase the pairing information of the speaker on your iPhone/iPod touch or computer, and then perform
the pairing procedure again.
The speaker can be paired with multiple devices, but can only play music from one paired device at a time.
The passkey of the speaker is “0000.” If a passkey besides “0000” is set on the BLUETOOTH device, pairing cannot be done with
the speaker.
When an audio cable is connected to the speaker’s AUDIO IN jack while the speaker and the BLUETOOTH device have been
connected via BLUETOOTH connection, sound from the BLUETOOTH device is not output from the speaker (the hands-free
function is available). To listen to music from the BLUETOOTH device, disconnect the audio cable from the speaker’s AUDIO IN
jack.
When using the Stereo Pair function or Party Connect function, you cannot use the multi-device connection.
Related Topic
Listening to music of a device via BLUETOOTH connection
Terminating the BLUETOOTH connection (After use)
Switching the BLUETOOTH devices connected at the same time (Multi-device-connection)
5-011-814-11(1) Copyright 2020 Sony Corporation
To Next Page
Loading...
Need help?
General
Weight and Dimensions
