Help Guide
Wireless Speaker
SRS-XB43
Terminating the Stereo Pair function
To terminate the Stereo Pair function, follow the procedure below.
Hint
If a portable audio device, etc. is connected to the AUDIO IN jack, the speaker automatically switches to AUDIO IN mode, and
the Stereo Pair function is terminated.
The Stereo Pair function will not be terminated even if the speaker is turned off. When the speaker is turned on again, the
speaker will attempt to establish a connection with the previously connected speaker for the Stereo Pair function. If you want to
use the Stereo Pair function, turn on the other speaker within 1 minute. While the BLUETOOTH standby function is activated,
however, the Stereo Pair function will be terminated.
If you want to use the speaker that had been used as one of the speakers of the Stereo Pair function by itself, press the
(power) button to turn on the speaker, then press the ST PAIR (Stereo Pair) button to terminate the Stereo Pair function.
To terminate the Stereo Pair function while using 2 speakers, press the ST PAIR (Stereo Pair) button. A beep is heard, and then
the Stereo Pair function is terminated.
Note
After you use the ST PAIR (Stereo Pair) button, be sure to close the cap securely.
The cap plays a very important role in maintenance of the waterproof and dust proof performance.
Related Topic
Using the BLUETOOTH standby function
Listening to music wirelessly with 2 speakers (Stereo Pair function)
5-011-814-11(1) Copyright 2020 Sony Corporation
Press the ST PAIR (Stereo Pair) button behind the cap located on the rear side of the speaker.
1
To Next Page
Loading...
Need help?
General
Weight and Dimensions
