Other Operations
59
GB
Using the Sleep Timer
You can set the receiver to turn off
automatically at a specified time by using the
remote.
For details, refer to the operating instructions
supplied with the remote.
STR-DA7ES
Use the supplied remote RM-TP1.
1 Touch RM SELECT.
2 Touch AMP in the RM SELECT screen.
3 Touch SLEEP while the power is on.
STR-DA4ES
Use the supplied remote RM-LP211.
Select SLEEP from the RECEIVER menu.
Each time you touch or press the button, the
display changes cyclically as follows:
2:00:00 t 1:30:00 t 1:00:00 t 0:30:00 t
OFF
While using Sleep Timer, “SLEEP” lights up in
the display.
Tip
To check the remaining time before the receiver turns
off, touch or press SLEEP. The remaining time
appears in the display.
Selecting the speaker
system
Set the SPEAKERS switch according to the
front speakers you want to drive.
Set to To select
A The speakers connected to the FRONT
SPEAKERS A terminals.
B The speakers connected to the FRONT
SPEAKERS B terminals.
A+B* The speakers connected to both the
FRONT SPEAKERS A and B
terminals (parallel connection).
The sound field is automatically set to
2CH STEREO.
OFF No speaker output
* Be sure to connect front speakers with a nominal
impedance of 8 ohms or higher if you want to select
both sets of front speakers (A+B). In this case, set
the IMPEDANCE SELECTOR to “4Ω”.
To Next Page
Loading...
Need help?
General