70
GB
Location of parts
1 ?/1 switch*
Press to turn the receiver on or off, or to
turn the 2nd (or 3rd) room output on or off.
2 Command mode buttons
Press to select the command mode.
Tips
• Each time you press a function button or other
operation buttons on the remote, the current
command mode button lights up.
• You can switch the command mode temporarily.
For example, when set to AV SYSTEM 1, if you
press CD/SACD while holding down AV SYSTEM
2, the signal for AV SYSTEM 2 mode is output.
Inserting batteries into the
remote
Insert two R6 (size-AA) batteries with the +
and – properly oriented in the battery
compartment. When using the remote, point it
at the remote sensor on the receiver.
Tip
Under normal conditions, the batteries should last for
about 6 months. When the remote no longer operates
the receiver, replace both batteries with new ones.
Notes
• Do not leave the remote in an extremely hot or
humid place.
• Do not use a new battery with an old one.
• Do not expose the remote sensor of the receiver to
direct sunlight or lighting apparatuses. Doing so
may cause a malfunction.
• If you don’t use the remote for an extended period
of time, remove the batteries to avoid possible
damage from battery leakage and corrosion.
]
}
]
}
Listening to the sound in another
room (continued)
To Next Page
Loading...
Need help?
General