© Sortimo International GmbH MA 00057 | 2022-01-11 | 5 7
Installing SoboPro
Step 3 — Attaching floor retainer clips
▶ Position the floor retainer clip.
▶ Carefully use a rubber hammer to secure the
floor retainer clip.
▶ Repeat these steps until all floor panels have
been connected to each other.
Step 4 — Aligning floor panels
▶ Align adjoining floor panels.
Note: The floor must have the same gap
from the vehicle chassis in all directions. The
following can be of assistance in this regard:
• Lashing points,
• Wheel housings.